Polestar 2 cup holder for the door drawer, New updated version, right side (1pc/passenger side)

3D printed, ASA (Acrylic Styrene Acrylonitrile) follows the shapes of the door side. UV and temperature resistant.

Black/dark gray that matches the Polestar 2's interior well.

Mounts easily in the door drawer without tools or equipment. Spring-loaded "barbs" for increased friction.

Changes in the new version

1. Covers the entire door pocket, giving a more complete and aesthetic appearance. Closes the hole on the back of the cup holder.
2. Roundings added to the bottom of the legs to make them less likely to scratch while installing in the door pocket (if you're still concerned, use some masking tape to remove afterwards)
3. The legs are slightly smaller, which makes it even easier to install in the door pocket, while the cup holder still has a nice tight fit in the door drawer.
4. Added roundings and chamfers around the legs to make the design even more robust.

Installation instructions;

Start by placing the cup holder sideways in the door drawer, and with a little force turn it 90 degrees down into the drawer, then it can be placed/slid forward so that the side of the cup holder follows the "buck" side of the door.